Automatic autoclave for sterilisation of cans by programmed temperature change cycles.
Heating and cooling system of the product by means of multidirectional stream of hot and cold pressurised water with diffuser nozzles.
Heating and cooling of the water, by steam or cold water, indirectly by means of heat exchange.
Customised load capacity, for 1, 2, 4 or 6 carts.
Two doors and automatic cart pulling system.
- AISI 304 6-mm thick stainless steel construction.
- Exterior lagging by means of fibreglass blanket, 44 mm thick and finish in shining stainless steel sheet metal.
- Load capacity depending on model, for 1, 2, 4 or 6 carts of cans.
- Door with safety interlock.
- Automatic pulling system for loading and unloading of carts by means of chains.
- Sterilisation system by showers of water with full cone diffuser nozzles from excess pressure by recirculation pump.
- Water heating and cooling in closed circuit by means of heat exchanger of AISI 316 stainless steel plates.
- Large water storage capacity in base of tank to provide maximum temperature stability to the system.
- Recirculation pump of stainless steel, variable strength according to the size and capacity of the equipment.
- Electrical power and control panel with individual protections, programmable automaton, and control panel.
- Pressure, temperature and time recorder.
- Summary table of process.
- Includes electro-pneumatic installation of the equipment.
- Includes programming of automaton.
- Pneumatic control valves.
- Pressure gauge and thermometer with calibration certification.
- CE Marking.
- Total power: variable depending on capacity.
- General dimensions: Variable length depending on capacity, approx. Ø1500 mm.